#200
Download MSDS
HB-200 is an adjustable veneer anchor. The L-shaped plate section has numerous ribs for added strength and 9/32" holes for connecting screws. The eyelets allow pintle insertion (1 1/4" maximum allowable eccentricity) and are sized to prevent in-and-out movement beyond allowable tolerances. Veneer can be reinforced with optional Seismiclip(R) Interlock System (9 gauge or 3/16" diameter continuous wire available).
Bonds masonry walls and restrains lateral movements while allowing expansion and control joints to perform as designed.
Download MSDS
Download MSDS
For bonding intersecting masonry walls.
Download MSDS
Ties masonry to steel columns, concrete or existing walls.
Download MSDS
Standard Sizes #10 or #12 x 1 1/2" - 5" Long.
Download MSDS
For anchoring masonry to structural column when masonry is parallel to column flange.
Download MSDS
Use in conjunction with #VWT Vee Wall Tie or #301W Column Web Tie. The systems anchor masonry to the structural frame allowing differential movement without any transfer of stresses.
Download MSDS
Welded onto steel web or flange to accept any type of Gripstay Anchor
Download MSDS
Finishes:
Download MSDS
PTA Series Partition Top Anchors have been developed to provide lateral shear resistance at the upper limit of masonry walls. They permit vertical deflection of the slab above, without transferring compressive loads to the masonry wall below. PTA Series Anchors are suitable for construction using steel or concrete.
Download MSDS
Round plastic weep holes manufactured from Medium Density Polyethylene (white).
Download MSDS
Standard: 2 1/4"
Medium: 2 7/8"
Large: 3 1/2"
Download MSDS
Configuration of louvers directs passage of water from cavity to outside of building, while inhibiting reverse passage of water.
Download MSDS
Quadro-Vent's honeycomb design allows passage of moisture from cavity to the building exterior while restricting ingress of insects and other debris. Quadro-Vent allows passage of moisture up to its 2 1/2" height, important in the event of mortar droppings at bottom of the cavity.
Download MSDS
The VS series is a complete line of polyvinyl chloride control joints suitable for various wall conditions. The PVC material conforms to ASTM D 2287 (Type PVC 654-4) with a durometer hardness of 85 (+ or - 5) when tested in conformance with ASTM D 2240.
Download MSDS
For placing horizontally beneath relieving angle, or in the vertical expansion joint to act as a control joint. Also prevents clogging of expansion joint with mortar.